dust extractor pleated filter cartridges is commonly used in cement, steel, electric power, food, metallurgy, chemical and other industrial areas. The overall capacity has increased several times and it has become a large dust collector (GB6719-86) with a filter area of > 2000m2. It is a solution to solve the old dust collector's difficulty in collecting dust, good filtering wind speed, poor cleaning effect, filter bag easy to wear and leak, and the operation cost is not low. Compared with all kinds of bag and electrostatic precipitator on the market, it has the characteristics of large filter area, low pressure difference, low emission, small volume, good service life and so on. It has become a new direction for the development of industrial dust collector.

Due to the high filtration load, the filter area required to handle the same smoke volume is less than the dust extractor pleated filter cartridges, so the device is compact and occupies a small area. The control system based on PLC programmable controller can control the dust removal, flue gas temperature, dust pressure and other operating parameters in real time, function and stability. Remove dust. The acceleration obtained by the surface of the filter bag during dust extractor pleated filter cartridges is much greater than that of other types of dust extractor pleated filter cartridges. High filtration load. Because of ash removal, even if the dust collector is running under a good filter wind speed, its resistance is not too high, generally 1200 ~ 1500Pa. Compared with the reverse filter, the dust extractor pleated filter cartridges has a large processing air volume under the same filter area.

The dust extractor pleated filter cartridges should be paid attention to in detail:

1. No-load operation: under no-load (no dust) condition, organize and observe the operating conditions of the dust removal equipment, especially the voltage, current, speed and vibration of the main fan, as well as the air volume, resistance and electric field characteristics of the dust collector; The integrity, continuity and applicability of the dust collector were evaluated by macroscopic qualitative evaluation. The overall function of the equipment was matched, the operation was continuous and the function was suitable.

Two, the treatment of major hidden dangers, to stress the spirit, take technology on the basis of view and discussion, buy very remove defects, improve the quality of equipment installation.

Iii. Tour inspection: The tour inspection of the dust removal system (especially the dust collector) is mainly to observe the dynamic operation of the no-load test, discover the problems, timely deal with the potential uncertainties in the installation process of dust removal equipment, correct errors, and improve the sound string of dust removal equipment.

Four, test verification: for the defects and hidden dangers found in the no-load test, after repair and treatment, to go through one or more test to verify; To be confirmed by test run verification. Reach the design target.

5. Dealing with defects: All equipment defects and hidden dangers found in the process of no-load test should be recorded, carefully discussed, and repaired to prevent further thinking.

dust extractor pleated filter cartridges is composed of an air inlet pipe, an air exhaust pipe, a box, a ash bucket, a ash cleaning device, a flow guide device, an air distribution plate, a filter cartridge and an electronic control device, which is similar to the dust removal structure of an air box pulse bag. The layout of pulse bag type dust collector is very important. It can be arranged vertically on the box box flower plate or tilted on the flower plate. From the effect of dust removal, the vertical layout is more correct. The lower part of the flower plate is the filter chamber, and the upper part is the air box pulse chamber. A airflow distribution plate is installed at the inlet of the dust collector.

dust extractor pleated filter cartridges https://www.kaisenfilter.com/Filter-Cartridges